Burak Cebe

DWG 02 · Lab

Lab

The things between the case studies: board plots, a motor on a palm, render films, events I ran. Switch to the index for the archive view.

7 entries
  1. KiCad A4 drawing sheet with a circular blue copper pour full of white through-hole pads, a sheet border with grid references and a title block in the corner.

    L01PCB2024-01-20

    RoboCup board, back copper

    KiCad 6.0.9 plot of the B.Cu layer on a full A4 sheet: copper pour, through-holes, the sheet frame and title block exactly as exported.

  2. KiCad layout of the small kicker board.

    L02PCB2023

    Kicker board

    Boost converter, MOSFET switching and optocoupler isolation for a solenoid kicker, on a board barely bigger than the capacitor footprint.

  3. KiCad layout of the ring-shaped line sensor board.

    L03PCB2023

    Line sensor ring

    Photodiodes and LEDs around a ring, read through MCP ADCs, to keep the robot inside the white line.

  4. A hand holding a small silver gearmotor labelled FK-130SH, DC 12V, above a wooden table.

    L04Parts2022-02-13

    12V gearmotor

    A small FK-130SH gearmotor, DC 12V, held up for scale.

  5. Exploded CAD view of purple and gold plates with green boards between them.

    L05CAD2023

    Robot chassis, exploded

    Three printed plates with the boards sandwiched between them.

  6. L06Vehicle2023–24

    Two go-karts

    Engineering Club project: fundraised for parts and built two drivable motor go-karts.

  7. L07Event2024-02

    CJCP Hacks

    The school's first interscholastic hackathon, organized through the CS Club.